BACKORDERED: Survey3W OCN, Survey3W NGB Expected Back in Stock in Q4 2021. Purchase Today to Reserve.
This discounted bundle has everything you'll need to use the Survey3 cameras with the DJI Inspire 1 drone. Our new tilting Inspire 1 mount allows you to lock the cameras in a tilted location such that during forward flight the cameras are parallel with the ground (nadir). The camera GPS cables will be shortened specifically for use on the Inspire 1 drone. Simply choose the number of cameras you want, the models of the cameras, and the micro SD memory capacity to complete your package.
Step 1: The mount will already come assembled. Simply unscrew the original DJI screws in the 4 locations marked in red below with a (not included) hex/allen tool:
Step 2: Place the mount as shown and tighten the 4 screws you just removed from the drone:
Step 3: Install the camera with a camera clip (not included). If using the Survey3 cameras, peel off the adhesive backing on the bottom of the GPS receiver, and press it such that the GPS receiver adheres to the top center of the mount.
Step 4: Unscrew the black side thumb knobs and slide the camera mount to the desired tilt location. Align the edge of the camera mount with the notch in the drone mount (the photo below shows a 0 degree tilt location). There are notches every 2.5 degrees from 0 to 20 degrees. Refer to the chart at the bottom to tilt according to your expected flight speed.