Advanced V2 GNSS Receiver

This Advanced V2 GNSS receiver for the Survey3 cameras provides increased image geolocation accuracy compared to our Standard GNSS and Advanced V1 GNSS. It has a 46% smaller volume and is 23% lighter weight compared to the Advanced V1 GNSS. Most notable is the improved positional accuracy and improved lock times, when compared to the Advanced V1 GNSS.

Inside the ublox MAX-M10S provides exceptional sensitivity and acquisition time for all L1 GNSS signals. The M10 platform supports concurrent reception of four GNSS (GPS, GLONASS, Galileo, and BeiDou). The high number of visible satellites enables the receiver to select the best signals. This maximizes the position availability, in particular under challenging conditions such as in deep urban canyons. u-blox Super-S (Super-Signal) technology offers great RF sensitivity and can improve the dynamic position accuracy with small antennas or in non-line-of-sight scenarios. For maximum sensitivity in passive antenna designs, MAX-M10S integrates an LNA followed by a SAW filter in the RF path.


  • Case Dimension: 33.0 x 28.0 x 10.0 mm 
  • Antenna Dimensions: 25 x 25 x 4 mm (ceramic patch)
  • Cable Length: Choose
  • Weight : 15.84g 
  • GNSS Receiver: ublox MAX-M10S
  • Output Protocol (Default): NMEA GNRMC and GNGGA
  • Refresh Rate: 10 Hz 
  • Positional Accuracy: 1.5m
  • Baud Rate: 115200
  • Port: JST-GH-6P
  • <200mA current draw
  • LEDs: Power (green), GPS lock (blue)
  • Operating Temperature: -40~80C
  • Input Voltage Supported: 4.7-5.2V
  • Rechargeable Farah capacitance
  • Low noise 3.3V regulator
  • Rechargeable 3V lithium backup battery
  • LNA MAX2659ELT+ RF Amplifier
  • Reprogrammable over UART using U-Center software

Advanced V2 GNSS Cable Details:

Pin 1: Ground (Black Wire)

Pin 2: GNSS Data TX (Green Wire)

Pin 4: 5V Power (Red Wire)