Included:

(1) Durable & lightweight plastic mounting plates

(2) DJI Inspire2 Bolts (M2.5 - 10mm)

(4) Dampening balls

(2) Thumb Screws

(1) Dual Survey camera mounting plate

Camera Mount Weight (not including camera clip(s), camera(s), GPS): 49.34g

MAPIR is in no way liable for any damage caused to or by your drone. We have thoroughly tested this mount and when installed properly will not interfere with the normal operation of the drone.

Install Instructions:

Step 1: Unscrew the original 2 DJI screws in the 2 locations marked in red below with a (not included) T9 torx tool:

Step 2: Place the mount as shown and tighten the 2 included screws:

Step 3: Install the camera with a camera clip (not included). If using the Survey3 cameras, peel off the adhesive backing on the bottom of the GPS receiver, and press it such that the GPS receiver adheres to the top center of the mount.

Step 4: Unscrew the black side thumb knobs and slide the camera mount to the desired tilt location. Align the edge of the camera mount with the notch in the drone mount (the photo below shows a 0 degree tilt location). There are notches every 2.5 degrees from 0 to 20 degrees. Every 5m/s is 5 degrees of tilt, so 10m/s speed would require 10 degrees of tilt.

Step 5: Happy flying!

DJI Inspire 2

Follow