This frame holds 6 LATTICE M3C/M3M modules in a vertical layout.

The L6V Chassis

The structural frame for a LATTICE L6V array: a 2 x 3 cage, two modules wide and three tall, that carries six camera modules on a common plane so every sensor stays coplanar and the bands land in register.

Why Vertical

Same six bays as the L6 frame, turned ninety degrees. Pole and mast installations, vehicle pillar and roll-bar brackets, greenhouse gantries, narrow gimbals, and conveyor lines all constrain mounting width far more than height, and a two-wide cage clears those brackets while presenting the same aperture area to the scene.

What You Get

Six mounting bays on a common front face, an integrated 1/4-20 tripod thread at the base, and open side and top walls that leave each module's aluminum heatsinks exposed to ambient air. The rear of every bay stays clear, so the M12 X-coded GigE Ethernet and M8 trigger connectors remain accessible without pulling the array apart.

Unlike the L1 through L4 frames, the larger cages do not take a ventilated cowl, and no sunshade is offered in this size. Weather protection comes from the modules themselves, each sealed to IP67 with waterproof rear connectors.

What You Don't Get

This is the bare chassis. Camera modules, heatsinks, M12-to-RJ45 Ethernet cables, and the 6-camera sync harness are all sold separately. The 6-camera harness fits both the L6 and L6V layouts.

If you would rather receive the array assembled, synchronized, and tested, order the complete LATTICE L6V array instead, or add the array assembly service to a parts order.