This frame holds 8 LATTICE M3C/M3M modules in a vertical layout.

The L8V Chassis

The structural frame for a LATTICE L8V array: a 2 x 4 cage, two modules wide and four tall, that carries eight camera modules on a common plane so every sensor stays coplanar and the bands land in register.

Why Vertical

Eight bays in a frame only two modules wide. It is the highest bay count MAPIR offers per centimeter of mounting width, which is what makes it fit where a 9-camera frame will not: pole and mast installations, vehicle pillar and roll-bar brackets, greenhouse gantries, narrow gimbals, and conveyor lines.

What You Get

Eight mounting bays on a common front face, an integrated 1/4-20 tripod thread in the base, and open side and top walls that leave the aluminum heatsinks exposed to ambient air. The rear of every bay stays clear, so the M12 X-coded GigE Ethernet and M8 trigger connectors remain accessible without pulling the array apart.

Unlike the L1 through L4 frames, the larger cages do not take a ventilated cowl, and no sunshade is offered in this size. Weather protection comes from the modules themselves, each sealed to IP67 with waterproof rear connectors.

What You Don't Get

This is the bare chassis. Camera modules, heatsinks, M12-to-RJ45 Ethernet cables, and the 8-camera sync harness are all sold separately.

If you would rather receive the array assembled, synchronized, and tested, order the complete LATTICE L8V array instead, or add the array assembly service to a parts order.