This frame holds 6 LATTICE M3C/M3M modules.

The L6 Chassis

The structural frame for a LATTICE L6 array: a 3 x 2 cage, three modules wide and two tall, that carries six camera modules on a common plane so every sensor stays coplanar and the bands land in register. It is one bay wider than the L3 and L4 frames, with six bays instead of four.

What You Get

Six mounting bays on a common front face, a mounting pad at the base, and open side and top walls that leave the aluminum heatsinks exposed to ambient air. The rear of every bay stays clear, so the M12 X-coded GigE Ethernet and M8 trigger connectors remain accessible without pulling the array apart.

The pad carries four 1/4-20 threads — the same thread as a standard tripod screw, four of them — so you can bolt the frame straight to your own bracket. The optional LATTICE Array Tripod Mount Plate adapts the pad to a single centered 1/4-20 for standard tripods, clamps, and heads.

Unlike the L1 through L4 frames, the larger cages do not take a ventilated cowl, and no sunshade is offered in this size. Weather protection comes from the modules themselves, each sealed to IP67 with waterproof rear connectors.

For the same six modules in a narrower profile, see the L6V frame, which stands the grid on end in a 2 x 3 layout.

What You Don't Get

This is the bare chassis. Camera modules, heatsinks, M12-to-RJ45 Ethernet cables, the 6-camera sync harness, and the tripod mount plate are all sold separately.

If you would rather receive the array assembled, synchronized, and tested, order the complete LATTICE L6 array instead, or add the array assembly service to a parts order.