Use this "plugs breakout board" to connect to your Kernel camera or Kernel array. It provides the following communications:
USB (including boot mode, useful to load different firmware onto the camera)
HDMI Video
SD Video (DAC)
PWM_IN / PWM_OUT
UAVCAN HIGH / LOW
UART RX / TX
POWER/GROUND
No cables are included with this item and must be purchased separately.
This board allows you to connect the power and USB to a computer and update the firmware of the camera. See the following details (and last item picture above) to set the board into each mode:
Normal Mode: move both white switches to numbered 1/2 position
Boot/Programming Mode: move both white switches to ON position